Aby zamontować celownik kolimatorowy Vortex Razor, C-More RTS lub STS, wystarczy usunąć tylny przyrząd celowniczy z Twojej broni i zastąpić go montażem EGW. Montaż można w każdej chwili zdjąć i ponownie zamontować tylny przyrząd celowniczy. W zestawie znajduje się niezbędny osprzęt montażowy. Instrukcja instalacji Usuń tylny przyrząd celowniczy* Zainstaluj montaż EGW w rowku W razie potrzeby dokręć śrubę ustalającą Umieść celownik kolimatorowy na montażu EGW (umieszczenie małego kawałka papieru między celownikiem kolimatorowym a montażem ułatwi późniejsze demontaż i zabezpieczy przed dostaniem się Loctite na celownik kolimatorowy.) Nałącz niebieski Loctite na dołączone śruby montażowe Dokręć śruby montażowe z momentem 15in/lbs Dołączone śruby do tego montażu wymagają klucza imbusowego 5/64'' do instalacji.
Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation.