KIMBER FIXED SIGHT VORTEX VIPER/VENOM SIGHT MOUNT - idealne rozwiązanie dla Twojego 1911!
EGW red dot sights są zaprojektowane do montażu od lewej do prawej (z lufą skierowaną do przodu). Dovetail ma progresywny taper, co ułatwia instalację. Wystarczy zdjąć tylną muszkę z broni i zastąpić ją montażem EGW, aby zamontować swój celownik red-dot Vortex Viper/Venom, Burris FastFire lub Docter. Możesz zdjąć montaż i ponownie założyć tylną muszkę w dowolnym momencie. W zestawie znajduje się sprzęt montażowy.
Instrukcje instalacji:
- Usuń tylną muszkę*
- Zainstaluj montaż EGW w dovetail
- Dokręć śrubę blokującą (jeśli dotyczy)
- Umieść celownik red-dot na montażu EGW (umieszczenie małego kawałka papieru między celownikiem a montażem ułatwi demontaż i zabezpieczy celownik przed Loctite)
- Nałóż niebieski Loctite na dostarczone śruby montażowe
- Dokręć śruby montażowe do 15in/lbs
W zestawie:
- 2 śruby z główką typu Button Head - przeznaczone do celowników Vortex Viper i Venom
- 2 śruby z główką typu Flat Head - przeznaczone do celowników Burris FastFire i Docter
Śruby dołączone do tego montażu wymagają klucza imbusowego 5/64'' do instalacji.
Zmiana konstrukcji Twojej broni może unieważnić gwarancję producenta.
Produkt powinien być zainstalowany i sprawdzony przez wykwalifikowanego rusznikarza.
Nie ponosimy odpowiedzialności za uszkodzenia lub obrażenia, które mogą wyniknąć z niewłaściwego montażu lub użytkowania tego produktu.
Ten montaż nie pasuje do:
- Kimber Micro
- Kimber Micro 9
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Kimber Micro Kimber Micro 9