Wysokiej jakości montaż do celowników red dot dla Twojego KIMBER 1911!
EGW red dot sights są zaprojektowane do montażu z lewej na prawą (z lufą skierowaną do przodu). Dovetail ma progresywny taper, co ułatwia instalację. Wystarczy usunąć tylny celownik z broni i zastąpić go montażem EGW, aby zamontować celownik Vortex Viper/Venom, Burris FastFire lub Docter. Możesz w każdej chwili zdjąć montaż i ponownie zamontować tylny celownik. W zestawie znajduje się sprzęt montażowy.
Instrukcje instalacji
- Usuń tylny celownik*
- Zainstaluj montaż EGW w dovetail
- Dokręć śrubę mocującą (jeśli dotyczy)
- Umieść celownik red dot na montażu EGW (umieszczenie małego kawałka papieru między celownikiem red dot a montażem ułatwi demontaż i zapobiegnie przyklejeniu Loctite do celownika).
- Nałóż niebieski Loctite na dostarczone śruby montażowe
- Dokręć śruby montażowe do 15 in/lbs
W zestawie:
- 2 śruby z główką typu Button Head - dostarczone do celowników Vortex Viper i Venom
- 2 śruby z główką typu Flat Head - dostarczone do celowników Burris FastFire i Docter
Śruby dołączone do tego montażu wymagają klucza imbusowego 5/64'' do instalacji. Ten montaż pasuje do:
- Kimber 1911 (regulowane tylne celowniki do windage i elevation)
- Ruger SR1911 (regulowane tylne celowniki do windage i elevation)
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount fits: Kimber 1911 (adjustable rear sights for windage and elevation) Ruger SR1911 (adjustable rear sights for windage and elevation)