Odkryj nowy poziom precyzji z montażem H&K USP TRIJICON RMR od EGW!
Ten montaż został zaprojektowany z myślą o maksymalnej funkcjonalności i trwałości. Oto szczegóły:
Opis produktu:
- Materiał: Aluminium 7075
- Powłoka: Matowa czarna hardcoat
- Długość całkowita: 1.780"
- Szerokość całkowita: 1.1"
- Hardware montażowy: (2) śruby płaskie 6-32, (1) śruba 6-32 X 3/16
- Dopasowanie do red dot: Trijicon RMR, Holosun HS507C
Ten montaż pasuje do:
- Baby Desert Eagle (po 2006 roku)
- EAA Witness Elite Match
Ten montaż nie pasuje do:
Aby zamontować swój celownik red dot Trijicon RMR, wystarczy zdjąć tylny celownik z broni i zastąpić go naszym montażem. Nie są wymagane żadne modyfikacje. Możesz w każdej chwili zdjąć nasz montaż i wymienić tylny celownik. Hardware montażowy jest dołączony.
Instrukcje montażu:
- Usuń tylny celownik*
- Zainstaluj montaż EGW w rowku
- Dokręć śrubę ustalającą (jeśli dotyczy)
- Umieść celownik red dot na montażu EGW (umieszczenie małego kawałka papieru między celownikiem a montażem ułatwi demontaż i zabezpieczy Loctite przed dostaniem się na celownik).
- Nałóż niebieski Loctite na dołączone śruby montażowe
- Dokręć śruby montażowe do 15 in/lbs
2 śruby płaskie - dołączone do Trijicon RMR
Śruby dołączone do tego montażu wymagają klucza imbusowego 5/64'' do instalacji.
Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.