Montuj swój celownik Vortex Viper/Venom na rewolwerze Ruger!
Usunięcie tylnych przyrządów celowniczych z broni i zastąpienie ich montażem EGW pozwala na łatwe zamocowanie celownika red-dot Vortex Viper/Venom, Burris FastFire lub Docter. Montaż można w każdej chwili zdjąć i przywrócić tylne przyrządy celownicze. W zestawie znajduje się niezbędny sprzęt montażowy.
Instrukcje instalacji
- Usuń tylny przyrząd celowniczy*
- Zainstaluj montaż EGW w rowku
- Dokręć śrubę blokującą (jeśli dotyczy)
- Umieść celownik red-dot na montażu EGW (umieszczenie małego kawałka papieru między celownikiem red-dot a montażem ułatwi demontaż i ochroni celownik przed Loctite)
- Nałóż niebieski Loctite na dostarczone śruby montażowe
- Dokręć śruby montażowe z momentem 15 in/lbs
W zestawie
- 2 śruby z główką typu Button Head - przeznaczone dla celowników Vortex Viper i Venom
- 2 śruby z główką typu Flat Head - przeznaczone dla celowników Burris FastFire i Docter
Do instalacji śrub dołączonych do tego montażu wymagana jest klucz imbusowy 5/64''.
Ten montaż nie pasuje do:
Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fit: Ruger Flattop Revolvers