Wysokiej jakości mocowanie celownika dla Desert Eagle Pre 2017
Mocowanie celownika EGW dla Vortex Viper/Venom to idealne rozwiązanie dla posiadaczy Desert Eagle Pre 2017. Dzięki innowacyjnej konstrukcji, montaż jest prosty i nie wymaga żadnych modyfikacji.
Opis produktu
Celowniki red dot EGW są przeznaczone do montażu z lewej na prawą stronę (z lufą skierowaną do przodu). Dovetail ma progresywny taper, co ułatwia instalację. Wystarczy usunąć tylny celownik z broni i zastąpić go mocowaniem EGW, aby zamontować celownik Vortex Viper/Venom, Burris FastFire lub Docter.
Instrukcje instalacji:
- Usuń tylny celownik*
- Zainstaluj mocowanie EGW w dovetail
- Dokręć śrubę blokującą (jeśli dotyczy)
- Umieść celownik red dot na mocowaniu EGW (umieszczenie małego kawałka papieru między celownikiem a mocowaniem ułatwi demontaż i ochroni celownik przed Loctite)
- Nałóż niebieski Loctite na dostarczone śruby montażowe
- Dokręć śruby montażowe do 15 in/lbs
W zestawie:
- 2 śruby z głową typu Button Head - przeznaczone do celowników Vortex Viper i Venom
- 2 śruby z głową typu Flat Head - przeznaczone do celowników Burris FastFire i Docter
Śruby dołączone do tego mocowania wymagają klucza imbusowego 5/64'' do instalacji. Proszę zwrócić uwagę na różnice między modelami Pre 2017 i Post 2017. Tylny półka za dovetail w modelu Pre 2017 ma .187", a w modelu Post 2017 .120".
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Please take note to the Pre 2017 and Post 2017 differences. Pre 2017 rear shelf behind the dovetail is .187"" and Post 2017 is .120".