Wysokiej jakości montaż kolimatora dla Desert Eagle Pre 2017
Montaż kolimatora EGW jest zaprojektowany specjalnie dla modelu Desert Eagle Pre 2017, umożliwiając łatwe zamontowanie celownika Leupold DeltaPoint Pro oraz innych kolimatorów.
Opis produktu
Kolimatory EGW są przeznaczone do montażu z lewej na prawą stronę (z wylotem w kierunku przodu). Szyna ma progresywny taper, co ułatwia instalację. Wystarczy zdjąć tylną muszkę z broni i zastąpić ją montażem EGW, aby zamontować swój celownik kolimatorowy.
- Usunięcie tylnej muszki*
- Zainstalowanie montażu EGW w szynie dovetail
- Dokręcenie śruby mocującej (jeśli dotyczy)
- Umieszczenie kolimatora na montażu EGW (umieszczenie małego kawałka papieru między kolimatorem a montażem ułatwi demontaż i zabezpieczy kolimator przed Loctite)
- Nałożenie niebieskiego Loctite na dostarczone śruby mocujące
- Dokręcenie śrub mocujących do 15 in/lbs
Zmiana w konstrukcji broni może unieważnić gwarancję producenta. Produkt ten powinien być zainstalowany i sprawdzony przez wykwalifikowanego rusznikarza. Nie ponosimy odpowiedzialności za szkody lub obrażenia, które mogą wyniknąć z niewłaściwej instalacji lub użycia tego produktu.
Uwaga
Ten montaż nie pasuje do:
- Desert Eagle Post 2017
- Baby Desert Eagle Post 2006
Proszę zwrócić uwagę na różnice między modelami Pre 2017 a Post 2017 przy składaniu zamówienia:
- Tylny brzeg za szyną dovetail w modelu Pre 2017 wynosi .187"
- Tylny brzeg za szyną dovetail w modelu Post 2017 wynosi .120"
EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Desert Eagle Post 2017 Baby Desert Eagle Post 2006 Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120"