Wysokiej jakości montaż do celownika Trijicon RMR dla Desert Eagle
Przedstawiamy montaż Trijicon RMR do Desert Eagle (PRE 2017) od marki EGW. Idealny dla miłośników strzelectwa, którzy pragną zwiększyć precyzję swoich strzałów.
Opis produktu
- Materiał: 7075 Aluminium
- Powłoka: Matowa czarna powłoka hardcoat
- Całkowita długość: 1.811"
- Całkowita szerokość: .99"
- Śruby montażowe: (2) 6-32 śruby płaskie, (1) 6-32 śruba zaciskowa
- Dopasowanie celownika: Trijicon RMR
Proszę zwrócić uwagę na różnice między wersją przed 2017 a po 2017 roku przy składaniu zamówienia:
- Tylny półka za dovetail przed 2017 wynosi .187"
- Tylny półka za dovetail po 2017 wynosi .120"
Aby zamontować celownik Trijicon RMR, wystarczy zdjąć tylny celownik z broni i zastąpić go naszym montażem. Nie są wymagane żadne modyfikacje. Możesz zdjąć nasz montaż i ponownie zamontować tylny celownik w dowolnym momencie. W zestawie znajduje się sprzęt montażowy.
Instrukcje instalacji
- Usuń tylny celownik*
- Zainstaluj montaż EGW w dovetail
- Dokręć śrubę zaciskową (jeśli dotyczy)
- Umieść celownik red dot na montażu EGW (umieszczenie małego kawałka papieru między celownikiem a montażem ułatwi demontaż i zapobiegnie przyklejaniu Loctite do celownika).
- Nałóż niebieski Loctite na dostarczone śruby montażowe
- Dokręć śruby montażowe do 15 in/lbs
2 śruby płaskie do kapelusza - dostarczone do Trijicon RMR
Śruby płaskie dołączone do tego montażu wymagają klucza imbusowego 5/64'' do instalacji.
Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.811" Overall Width: .99" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw Red Dot Fitment: Trijicon RMR Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120" Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trjicon RMR The flat head screws that are included with this mount require a 5/64'' allen wrench for installation.