Po prostu usuń tylną muszkę z broni i zamień ją na montaż EGW, aby zamontować celownik kolimatorowy Trijicon RMR. Możesz zdjąć montaż i w każdej chwili wymienić tylną muszkę. W zestawie znajduje się sprzęt montażowy. Instrukcje instalacji Usuń tylną muszkę* Zainstaluj montaż EGW w rowku Dokręć śrubę mocującą (jeśli dotyczy) Umieść celownik kolimatorowy na montażu EGW (umieszczenie małego kawałka papieru między celownikiem kolimatorowym a montażem ułatwi demontaż i zapobiegnie dostaniu się Loctite'a na celownik kolimatorowy.) Nałóż niebieski Loctite na dostarczone śruby montażowe Dokręć śruby montażowe do 15in/lbs 2 śruby z łbem płaskim - dostarczone dla Trijicon RMR Śruby dołączone do tego montażu wymagają klucza imbusowego 5/64'' do instalacji. Ten montaż nie pasuje do: Sig P320 RX, Sig P320 X-Five (z wycięciem Romeo1), Sig M17 Military Surplus
Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Trijicon RMR red dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fit: Sig P320 RX Sig P320 X-Five (with Romeo1 cut) Sig M17 Military Surplus